In addition to high efficiency, heat pumps can also be used for space cooling too
Heat pumps are devices that use the environment to meet the demands for space heating and cooling and DHW preparation at very high efficiency level. In its portfolio, Centrometal has air/water type heat pumps in monobloc and split version, with nominal heating capacities from 4 to 16kW. There is also an option to have up to five heat pumps in cascade mode. The monoblock version advantage is that all of its components are out of the house and that the regrigerant is factory prefilled, so the installer has to connect water pipes to the heat pump only, but must insulate these pipes well. In the split version the installer must connect the outdoor unit (in which the compressor is placed) to the indoor unit (in which the exchanger and the pump are placed) with refrigerant pipes. Due to the higher efficiency, heat pumps are intended for low-temperature heating / cooling systems (underfloor heating and fan coil units). In addition to high efficiency, heat pumps can also be used for space cooling, which is a great advantage over traditional heating systems. For such a heating / cooling system in the house, it is necessary to provide only 1m2 of space in some technical room, ie. there is no need for a boiler room, while 0.5m2 is enough on the outside of the house.

More about heat pumps

  • Heating/cooling

    In addition to high efficiency, heat pumps can also be used for space cooling, which is a great advantage over traditional heating systems.

  • No boiler room

    It is necessary to provide only 1m2 of space, while 0.5m2 is enough on the outside of the house.

  • No chimney

    There is no need to build a chimney.

  • Autonomy

    No cleaning and refueling is required as with conventional boilers.

Touchscreen control unit:

  • It allows direct interaction with the content displayed on the screen.
  • User-friendly interface for heat pump control.
  • It can control up to two mixing heating/cooling circuits, one direct heating/cooling circuit and DHW tank preparation (with circulation pump and immersed electric heater).
  • It can control backup electric heater (IBH) and additional heat source (AHS) and it can control up to five heat pumps in cascade mode.
  • It can be connected to floor heating/cooling, fan coil units or low-temperature radiator heating.
  • There is an option of monitoring and controlling the heat pump via web portal.

WATCH THE VIDEO - The most important characteristics of the Cm heat pumps

Characteristics table - Monoblok

Characteristics - SPLIT

Centrometal d.o.o. shall not be responsible for possible incorrect data caused by error made in transcription and all figures and diagrams are for explanatory purposes only and relevant adjustment have to be made at the spot. In any case, it reserves the right to modify its products as deemed to be required and useful without any prior notification.