TB

💧 Available volumes

Hot water boilers TB with a volume of 120 to 850 liters are intended for heating and accumulating domestic hot water by connecting it to the boiler circuit in the boiler room or to another heat source within a technological process. They are often installed with solar systems as an additional accumulation with solar boilers STB.

The boilers are made of high-quality stainless steel, which guarantees high hygienic conditions. The use of modern technologies and proven technical solutions enables a high heat transfer coefficient and negligible losses to the environment. They are manufactured in accordance with ISO 9001 and ISO 14001.

🛒 Where to buy? 🛠️ Authorized service
TB
Run 3D model
  • SOLAR SYSTEMS

    SOLAR SYSTEMS

    They are often installed next to solar systems as additional storage with STEB solar water heaters.
  • STAINLESS STEEL

    STAINLESS STEEL

    The boilers are made of stainless steel, which guarantees high hygienic conditions.
  • EFFICIENCY

    EFFICIENCY

    By using modern technologies and proven technical solutions, a high heat transfer coefficient and negligible losses to the environment are enabled.
  • ISOLATION

    ISOLATION

    The 80 mm thick insulation layer effectively protects the boiler from heat loss.
TB TB TB

Product characteristics

  • Hot water boilers TB with volumes of 120, 150, 200, 300, 600 and 850 liters are intended for heating and accumulating domestic hot water by connecting to the boiler circuit or to another heat source within a technological process.
  • They are suitable for installation in solar systems, as additional accumulation with solar boilers STB.
  • The boilers are made of high-quality stainless steel, which guarantees high hygienic conditions.
  • Due to the rapid heating by the large heating surface of the tube exchanger, they provide the comfort of large quantities of hot water.
  • In the boilers TB 120 and 150, the connections are located on the top of the boiler, while in the boilers TB 200, 300, 600 and 850, the connections are on the back of the boiler, which allows for simple and quick connection to the installation.
  • It is possible to install a sensor for this purpose on the back of the boiler.
  • The 80 mm thick insulation layer effectively protects the boiler from heat loss.

Technical instructions

Technical instructions - TB

Brochure

Brochure

Delivery and installation

  • Hot water stainless steel TB boilers are supplied with 80 mm thick thermal insulation coated with hard plastic on the outside.
  • At the cold sanitary water inlet to the boiler, it is mandatory to install:
    - expansion tank for sanitary water
    - tap for draining water from the boiler (mandatory via T-piece)
    - certified safety valve with an opening pressure of 6 bar (0.6 MPa),
    - non-return valve
    - pressure reducing valve that reduces the pressure of the cold sanitary water inlet to 4 bar (0.4 MPa) (if its pressure is higher).