WP/E 1500
💧 Available volumes
WP/E enamelled hot water boilers with volumes of 1500 litres are intended for heating and accumulating domestic hot water by connecting it to a heat pump circuit in a boiler room or technical room. The tanks are double-layered enamelled according to DIN 4753. They are manufactured in accordance with the European standard EN 12897:2014 and have one heat exchanger.
-
LARGE SPIRAL
They are often installed alongside heat pumps because of their large spiral. -
ENAMELLED
According to DIN 4753. -
EFFICIENCY
By using modern technologies and proven technical solutions, a high heat transfer coefficient and negligible losses to the environment are enabled. -
ISOLATION
The 600/100 insulation layer effectively protects the boiler from heat loss.
Product characteristics
- Hot water boilers WP/E with volumes of 1500 liters are intended for heating and accumulating domestic hot water by connecting it to a boiler circuit or to another heat source within a technological process.
- They are suitable for installation with heat pumps.
- The tanks are double-layered enameled according to DIN 4753.
- Due to the large spiral, they are suitable for low-temperature heat sources.
- The insulation layer effectively protects the boiler from heat loss.
WP/E
Technical instructions
Technical instructions - WP/E
Brochure
Brochure - WP/E
Delivery and installation
The hot water boiler WP/E is delivered on a pallet with separate insulation (WP/E 800-2000), a thermometer and a protective magnesium anode.
- At the cold sanitary water inlet to the boiler, it is mandatory to install:
- expansion tank for sanitary water
- tap for draining water from the boiler (mandatory via T-piece)
- certified safety valve with an opening pressure of 6 bar (0.6 MPa),
- non-return valve
- pressure reducing valve that reduces the pressure of the cold sanitary water inlet to 4 bar (0.4 MPa) (if its pressure is higher).
