WP/E

💧 Available volumes

WP/E enamelled hot water boilers with volumes of 200, 300, 400, 500, 600, 800, 1000, 1250, 1500, 1750 and 2000 litres are intended for heating and accumulating domestic hot water by connecting it to a heat pump circuit in a boiler room or technical room. The tanks are double-layered enamelled according to DIN 4753. They are manufactured in accordance with the European standard EN 12897:2014 and have one heat exchanger.

🛒 Where to buy? 🛠️ Authorized service
WP/E
  • LARGE SPIRAL

    LARGE SPIRAL

    They are often installed alongside heat pumps because of their large spiral.
  • ENAMELLED

    ENAMELLED

    According to DIN 4753.
  • EFFICIENCY

    EFFICIENCY

    By using modern technologies and proven technical solutions, a high heat transfer coefficient and negligible losses to the environment are enabled.
  • ISOLATION

    ISOLATION

    The 600/100 insulation layer effectively protects the boiler from heat loss.
WP/E WP/E WP/E WP/E WP/E

Product characteristics

  • Hot water boilers WP/E with volumes of 200, 300, 400, 500, 600, 800, 1000, 1250, 1500, 1750 and 2000 liters are intended for heating and accumulating domestic hot water by connecting it to a boiler circuit or to another heat source within a technological process.
  • They are suitable for installation with heat pumps.
  • The tanks are double-layered enameled according to DIN 4753.
  • Due to the large spiral, they are suitable for low-temperature heat sources.
  • The insulation layer effectively protects the boiler from heat loss.

Delivery and installation

The WP/E hot water heater is delivered on a pallet with factory-mounted insulation (WP/E 200-600) or separate insulation (WP/E 800-2000), thermometer and protective magnesium anode.

  • At the cold sanitary water inlet to the boiler, it is mandatory to install:
    - expansion tank for sanitary water
    - tap for draining water from the boiler (mandatory via T-piece)
    - certified safety valve with an opening pressure of 6 bar (0.6 MPa),
    - non-return valve
    - pressure reducing valve that reduces the pressure of the cold sanitary water inlet to 4 bar (0.4 MPa) (if its pressure is higher).

Additional equipment

Electric heater for sanitary water boiler